Joint-It Simple Grey 20kg.
For joints at least 3mm wide and 25mm deep.
Where other grouts and mortars can crack and loosen, allowing weeds to grow, Joint-It Simple sets rock hard. It is specially formulated with 7 unique, specialist glues to ensure that it will stay in your joints for many years to come. Our simple to use, premium patio grout makes jointing an effortless task.
Minimum Effort, Maximum Results:All you need is a hard and soft brush, water, and a bucket of our mortar mix.
Key Features:
* Ready to Use Formulation * Easy Application * Suitable for Porcelain * Long lasting * Non-staining * Weed, Power-washer & Frost Resistant * Apply in wet or dry weather * Larger 20KG buckets – Better value * Water-Permeable * Available in 4 colours – Neutral, Grey, Dark Grey & Black * Eco-Friendly 97% Natural
Simple To Use Jointing Grout
Follow our easy, 4 step application to save your valuable time without compromising quality.
Our natural sands harden on contact with air, so simply wet the area, brush in the product, and leave it to do the rest. Suitable for use by professional contractors and homeowners.
Jint-It Simple Step by Step Guide:
1. Soak with Water
You must soak your finished paving with water before you open your bucket of Joint-It Simple.
Keep the paving soaked with water while you work. Do not allow the paving to dry as you work with the product. Keep re-wetting the paving as you work.
2. Open Joint-It Simple
The product is vacuum packed tightly inside the bag.
Open the bag and tip the product out onto your wet paving.
3. Applying Joint-It Simple
Use a hard bristle brush to work the product into the joints. You must soak your paving with water before you start to sweep Joint-It Simple into the joints.
Keep the paving soaked with water while you work. Do not allow the paving to dry as you work. Keep re-wetting the paving as you work with the product.
4. Soak Again
When all of the joints are full of product, and the paving looks like this, then soak the paving again with water.
Allow the paving and product to dry. Depending on weather conditions, this will take between 15 and 45 minutes approximately.
5. Sweep in Joint-It Simple
Using a soft bristle brush, sweep over the paved area and top up joints with product until all of the joints are completely full.
Sweep up and remove any excess product.
Joint-It Simple - Safety Datasheet
Registered Customers